PIONEERPOS AT Commands G24-LC - Manual (Page 161)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-97
Table 3-57: <fo> for SMS-DELIVER Message
Bit/s Reference Description
0-1 Message-Type-Indicator Parameter describing the message type.
0 0 SMS-DELIVER (in the direction SC
to MS)
2 TP-More-Message-To-Send Parameter indicating whether or not more
messages are waiting to the MS in the
SC.
0 More messages are waiting for the MS
in this SC
1 No more messages are waiting for the
MS in this SC
5 TP-Status-Report-Indication Parameter indicating if a status report is
requested by the MS
0 A status report is not requested
1 A status report is requested
6 TP-User-Data-Header-Indicator Parameter indicating whether or not a
status report will be returned to the SME.
0 A status report will not be returned to
the SME
1 A status report will be returned to the
SME
7 TP-Reply-Path Parameter indicating that Reply Path is
set or not.
0 TP-Reply-Path parameter is not set
1 TP-Reply-Path parameter is set
Table 3-58: Layout of SMS-STATUS-REPORT in PDU Mode (according to
GSM03.40)
Reference Description Length
<sca> Mandatory:
Service Center address:
1
BYTE: length (number of
followed octets)
Mandatory:
1
BYTE: <tosca> - value between
128-255
1, 3-12 BYTES
(When length is 1, length BYTE = 0 )
<fo> Mandatory:
First Octet. See
Table 3-59 .
1 BYTE
<mr> Mandatory:
Message Reference number, which
identifying the previously submitted
SMS-SUBMIT or SMS-COMMAND 1 BYTE