PIONEERPOS AT Commands G24-LC - Manual (Page 269)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-205
Example
ats100?
001
OK
ats100=0
OK
ats100?
000
OK
+MSCTS, Enable/Disable CTS During Wakeup Period
This command defines the behavior of the CTS line when the G24-L is in normal mode (not
Sleep mode).
The command configures the G24-L CTS line behavior always to follow the flow control
requirements, or to follow it only if the terminal initiated a serial transmission session. This saves
the terminal from following the CTS interrupt every time the G24-L exits Sleep mode for internal
G24-L reasons (non-terminal communication related reasons).
Table 3-137: Command parameters
<Parameter> Description Remarks
<delta> Time interval between one burst of sent/received
data to the other before the terminal enters sleep
mode.
0 : Wakeup out feature isn't active. (default when
+S100 set command is never used)
1 - 255: Time in seconds. This value is saved on power
down.
Command
Type Syntax Response/Action Remarks
Set AT+MSCTS=<control> OK The Set command tells the G24-L
whether to activate the CTS when the
unit is awakening.
Read AT+MSCTS? +MSCTS: <current
control>
OK
The Read command returns the current
control value.
Test AT+MSCTS=? +MSCTS: (list of
supported <control>)
OK
The Test command returns the possible
control values.