PIONEERPOS AT Commands G24-LC - Manual (Page 412)

AT Commands Alphabetical Summary
A-10 G24-L AT Commands Reference Manual April 15, 2008
+EMPC This command unlocks or
resets the first PLMN of the
inserted SIM. Page 3-187
+EPIN This command is only relevant
for phones that use SIM cards. It
verifies the PIN2 indicator. Page 3-181
+FMI This command requests
manufacturer identification. Page 3-1
+FMM This command requests the
model identification. Page 3-2
+FMR This command requests the
revision identification. Page 3-3
+GMI This command requests
manufacturer identification. Page 3-1
+GMM This command requests the
model identification. Page 3-2
+GMR This command requests the
revision identification. Page 3-3
+GSN This command requests the
product serial number
identification. Page 3-3
+ICF This command determines the
local serial port start/stop
(asynchronous) character framing
used by the DCE when accepting
DTE commands and transmitting
information text and result codes,
whenever these are not done
automatically. Page 3-142
+IPR This command is responsible for
setting and saving the request
baud rate. Page 3-133
+MADIGITAL This command switches between
analog and digital audio modes. Page 3-170
+MAFEAT This command controls the
various algorithm features, such
as sidetone, echo cancel and
noise suppress. Page 3-169
+MAMUT This command controls the
muting/unmuting of all input
paths (MIC, HDST_MIC,
DIGITAL_RX). Page 3-168
+MAPATH This command sets/requests the
active input accessory, and the
output accessory for each feature. Page 3-163
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page