PIONEERPOS AT Commands G24-LC - Manual (Page 344)

GPRS
3-280 G24-L AT Commands Reference Manual April 15, 2008
The +MIPODM command returns a +MIPSTAT <Socket ID><Error> unsolicited event
if it fails. For example, if it was rejected by the remote side.
Command Type Syntax Response/Action Remarks
Set AT+MIPODM=
<Socket ID>,
<Source Port>,
<Remote IP>,
<Remote Port>,
<Protocol>
OK
or:
+MIPODM: <Socket
ID>,<State>[,<Remote IP>,<Remote
Port>]
or:
+MIPSTAT: <Socket ID>,<Status>
or:
ERROR: <err>
The Set command returns
<Remote IP> and
<Remote Port>
parameters only for
sockets opened in Listen
mode.
Read AT+MIPODM? +MIPODM:[<SocketID>]
for each socket that can be opened
or:
+MIPODM 0,0
if there are no free sockets.
When a socket opens in
Online Data Mode, the
command returns actual
Socket ID value and '1'
value (active). G24-L
will be in
pseudo-command mode
for receiving the
command.
Test AT+MIPODM=? +MIPODM: (list of supported
<socket ID>s),(list of supported
<source port>s),(list of
supported<"Destination IP">s),
(list of <destination port>s),(list of
supported <protocol>s)