PIONEERPOS AT Commands G24-LC - Manual (Page 330)

GPRS
3-266 G24-L AT Commands Reference Manual April 15, 2008
The following table describes the events types.
Table 3-188: Current Event Types
Event Notes
MT Call Event Performed by G24; no indication sent to the TE.
Call Connected Event Performed by G24; no indication sent to the TE.
Call Disconnected Event Performed by G24; no indication sent to the TE.
Location Status Event Performed by G24; no indication sent to the TE.
User Activity Event Initiated by TE and reported via +MTKP command. TE is
responsible for deciding what triggers this event. Only the event
occurrence is monitored by G24; no additional information is
required.
Idle Screen Available Event Initiated by TE and reported via +MTKP command. TE is
responsible for deciding what triggers this event. Only the event
occurrence is monitored by G24; no additional information is
required.
Card Reader Status Event Issued by message handler of SCIM_CARD_DETECT_IND_ID
message. Performed by G24; no indication sent to the TE.
Language Selection Event TE is responsible for deciding what triggers this event. +MTKP
command contains a data portion with language code – a pair of
alphanumeric characters (defined in ISO 639 [29]), each of which is
coded on one byte using the SMS default 7-bit coded alphabet, as
defined in TS 23.038, with bit 8 set to 0.
Browser Termination Event Initiated by TE and reported via +MTKP command. The command
contains a data portion that includes the cause of termination:
0
User terminated
1 Error terminated
TE is responsible for deciding what triggers this event.
Data Available Event Performed by G24; no indication sent to the TE.
Channel Status Event Performed by G24; no indication sent to the TE.
Command Type Syntax Response/Action Remarks
Set +MTKP=16,<result
>[,<Data>]
OK
or:
+CME ERROR: <err>
The Set command
defines the event type.
Test +MTKP=? OK