PIONEERPOS AT Commands G24-LC - Manual (Page 113)

Chapter 3: AT Commands Reference
April 15, 2008 G24-L AT Commands Reference Manual 3-49
Note: If <ppu> contains a dot, a maximum of three digits may appear after the dot, otherwise
an error is generated. For example, if <ppu>=0.61, the Read command displays 0.610.
<ppu>=1.2345 terminates in an error.
If <ppu> does not contain a dot, the number is divided by 1000. For example, if <ppu>=1,
the Read command displays 0.001.
Due to storage constraints, the <ppu> value is limited to a range of 0 to 4095. Values
beyond this range may result in rounding errors. For example, if <ppu>=4095, the Read
command displays 4.095. However, if <ppu>=4096, the Read command displays 4.090
(the last digit is replaced by 0). If <ppu>=456789, the Read command displays 456.000.
+CR, Service Reporting Control
This command controls whether or not the extended format of an outgoing call is displayed or
not. The +CR indication is sent from the G24-L to the terminal whenever a data call is initiated by
the G24-L.
The following table shows the +CR parameters.
Example
AT+CR=1 //Enable reporting
OK
ATD1234567890
+CR: REL ASYNC
Command Type Syntax Response/Action Remarks
Set +CR=[<mode>] OK The Set command enables/disables the
extended format of an outgoing data
call. When enabled, the outgoing data
call is indicated to the terminal through
the unsolicited result code
+CR:<serv>. When the command is
disabled, no +CR is sent to the
terminal.
Read +CR? +CR:<mode> The Read command displays the
current service reporting control
setting.
Test +CR=? +CR:<mode> The Test command displays the list of
supported CR modes.
Table 3-25: +CR Parameters
<Parameter> Description
<mode> 0 Extended format disabled (default)
1 Extended format enabled
<serv> Type of outgoing data calls:
ASYNC - Asynchronous transparent
SYNC - Synchronous transparent
REL ASYNC - Asynchronous non-transparent
REL SYNC - Synchronous non-transparent