Mggind, gsm/gprs service indicator, Mggind, gsm/gprs service indicator -140, Mggind parameters -140 – PIONEERPOS AT Commands G24-LC User Manual
Page 204
Hardware Information
3-140
G24-L AT Commands Reference Manual
April 15, 2008
+MGGIND, GSM/GPRS Service Indicator
This command configures the service indicator line of pin 49 of the 70 pin connector to be GPRS
or GSM registration indicator.
The IO line (pin 49) function according to the current registration state (in service or not) of the
specific service indicator configuration.
Note:
IO line (pin 49) outcome depends on +MCWAKE configuration.
The following table shows the +MGGIND parameters.
Example
AT+MGGIND=0
OK
AT+MGGIND?
OK
+MGGIND: 0
AT+MGGIND=1
OK
AT+MGGIND?
+MGGIND: 1
OK
AT+MGGIND=?
+MGGIND: (0-1)
OK
Command Type
Syntax
Response/Action
Set
AT+MGGIND=<state>
OK
or:
+CME ERROR: <err>
Read
AT+ MGGIND ?
+MGGIND: <state>
OK
or:
+CME ERROR: <err>
Test
AT+ MGGIND =?
+MGGIND: (list of supported
<state>s)
OK
Table 3-91: +MGGIND Parameters
<Parameter>
Description
<state>
0
GPRS registration indicator.
1
GSM registration indicator.