YSI IQ SensorNet 2020 XT Terminal - Manual (Page 157)

System 2020 XT USB Settings/setup
5 - 37 ba76019e01 12/2012
5.12.1 Setting the recording interval (dt) and recording duration
(Dur.)
Fig. 5-21 Measured value logging
1 Using <S>, open the Settings menu.
2 Using <
> and <OK>, select and confirm the menu
item, Measured value logging -> .
The Measured value logging display opens.
It contains a list of all sensors and inactive sensors.
3 Press < > and <OK> to select and confirm the dt
column.
4 Press <
> and <OK> to select and confirm a sensor.
5 Determine the recording interval with <
> and <OK>.
When the recording interval is changed, the recording duration
changes at the same time (Dur.), because the recording
duration results from the recording interval due to a fixed
number of memory blocks.
6 Switch to the selection of columns with <ESC>.
7 Press < > and <OK> to select and confirm the Dur.
column.
8 Press <
> and <OK> to select and confirm a sensor.
9 Select the recording duration with < > and <OK>.
The recording duration is always increased or decreased in the
same steps.