YSI IQ SensorNet 2020 XT Terminal - Manual (Page 147)

System 2020 XT USB Settings/setup
5 - 27 ba76019e01 12/2012
Entering the name of a
measuring location
The name of the measurement location is displayed in the line with the
name of the display. 15 characters are available for the name of the
measurement location.
Selecting sensors for
the measured value
display on the
measurement location
The measured value display provides the option of displaying either all
sensors or a selection of sensors (see section 4.4.4).
As soon as a terminal is docked on any MIQ module, the selected
sensors at the measurement location are displayed. All sensors for the
display at the measurement location are activated in the delivery state.
The sensors are selected in the Select measured values of location
menu. This selection is stored in the MIQ module on which the terminal
is docked.
3 Press < > to select the name of the display, Select
measured values of location and confirm with <OK>.
4 Press <
> and <OK> to enter the location name and
finally confirm with <OK> (see also section 4.2.2).
5 Select and confirm sensors for the local measured value
display with <
> and <OK>. This sets or removes a tick
(
✔) for the individual sensors.
Sensors selected for the display are marked with a tick (
✔).