YSI IQ SensorNet 2020 XT Terminal - Manual (Page 47)

System 2020 XT USB Installation
3 - 17 ba76019e01 12/2012
Stacking the
MIQ modules
Fig. 3-7 Stacking the MIQ modules (variant 1)
Fig. 3-8 Closing the enclosure (variant 1)
7 Attach the prepared MIQ module to the lid of the back
MIQ module. At the same time, ensure that the two clips on the
front MIQ module click into place in the lid of the back
MIQ module. Subsequently, tighten the two screws (pos. 8 in
Fig. 3-6).
8 Check the position of the SN terminator switch and correct it if
necessary (see section 3.9.1).
9 Close the lid of the front MIQ module and fix it with the two
countersunk screws (pos. 7 in Fig. 3-8).
7