YSI IQ SensorNet 2020 XT Terminal - Manual (Page 110)

Operation System 2020 XT USB
4 - 32 ba76019e01 12/2012
4.9 Data exchange via the USB interface
With the USB interface the MIQ/TC 2020 XT provides a very simple
way to
 Save data of the IQ S
ENSOR N ET on a USB memory device (see
section 4.9.1)
 Transmit data to a PC with the aid of a USB memory device
 Transmit configuration data to the controller
4.9.1 Saving IQ S ENSOR N ET data on a USB memory device
You can save the following data types:
 Configuration data (see section 4.9.3)
 Measurement data (see section 4.9.2)
 Log book
 Calibration history
From the USB memory device, the configuration data can be copied
back to the IQ S
ENSOR N ET . Thus you can very easily create systems
that are configured identically.
Saving data Saving measurement data via the USB interface is only recommended
if the MIQ/TC 2020 XT is configured as terminal/controller.
Note
If it is configured as a terminal, the data is first sent form the controller
to the termina via the IQ S
ENSOR N ET . This can take several hours with
great amounts of data.
1 Switch to the measured value display with <M>.
2 Using <S>, open the 100 - Settings menu.
3 Using <
> and <OK>, open the menu, Data transfer to
USB memory.