YSI IQ SensorNet 2020 XT Terminal - Manual (Page 137)

System 2020 XT USB Settings/setup
5 - 17 ba76019e01 12/2012
5.6.3 Adjusting the settings for sensors/differential sensors
Sensor settings include the measured parameter, measuring range
and, if necessary, compensations.
Note
General steps for the selection of sensor settings are given below.
Details on sensor settings are given in the operating manual for the
IQ sensor.
Note
If the measuring mode or measured parameter are changed, a link of
the sensor with a relay is erased!
Fig. 5-10 Settings of sensors and diff. sensors
1 Using <S>, open the Settings menu.
2 Using <
> and <OK>, select and confirm the menu
item, System settings -> Settings of sensors and diff. sensors.
The Settings of sensors and diff. sensors display opens.
3 Using < >, highlight the Measuring range column.
Confirm with <OK>. An information window opens up.
4 Confirm the information with <OK>.
The Link with... display opens.
5 Using <
>, select a sensor and confirm with <OK>.
The current settings are displayed.