YSI IQ SensorNet 2020 XT Terminal - Manual (Page 111)

System 2020 XT USB Operation
4 - 33 ba76019e01 12/2012
Note
You can cancel the data saving process by selecting and confirming
Cancel with <
> and <OK>. The data will then not be stored on
the USB memory device.
4 Select the data to be saved with <
>.
 Save configuration
 Measured data storage
 Log book
 Calibration history
and confirm with <OK>.
5 The data is prepared for transmission.
Only for backing up the measurement data memory:
4-1 A list of sensors is displayed for which stored measured
values are available.
4-2 Using <
>, select the Selec. column. Confirm
with <OK>.
Using <
>, select the sensors. Place a
checkmark with <OK>. The measurement data of the
sensor is included in the backup.
Include further sensors in the list of measurement data
to be saved as necessary.
4-3 Terminate the selection of sensors with <ESC>.
4-4 Using < >, select the menu item, Transfer data
for selected sensors and confirm with <OK>.
A dialog box pops up for the selection of the decimal
separator for the exported *.csv file.
4-5 Using < >, select the decimal separator (comma
or dot) for the measurement data. Confirm with <OK>.
A query pops up concerning the restart of the measured
value recording.
4-5 Using <
>, select Yes or No. Confirm with <OK>.
If the restart of the measured value recording is
selected, the measurement data stored in the
IQ S
ENSOR N ET is erased after storing. The measured
value recording is restarted.