YSI IQ SensorNet 2020 XT Terminal - Manual (Page 53)

System 2020 XT USB Installation
3 - 23 ba76019e01 12/2012
Fig. 3-15 Connecting cables to the MIQ module
3 Screw the cable gland (pos. 1 in Fig. 3-15) with the sealing ring
(pos. 2) into the module housing.
4 Loosen the coupling ring (pos. 3 in Fig. 3-15).
5 Feed the cable through the cable gland into the module
housing.
6 Connect the cable ends to the terminal strip. At the same time,
look out for the designations of the terminals (red / shield /
green).
7 Tighten the coupling ring (pos. 3 in Fig. 3-15).
8 Check the position of the SN terminator switch and correct it if
necessary (see section 3.9.1).
9 Close the MIQ module.
SENSORNET 2
SENSORNET 1
SACIQ SNCIQ
SNCIQ/UG
1
3
2
X6 X5 X4
SENSORNET 2
X3 X2 X1
SENSORNET 1
RED RED SHIELD SHIELD GREEN GREEN ON
OFF
SN
TERMINA
TO
R