YSI IQ SensorNet 2020 XT Terminal - Manual (Page 48)

Installation System 2020 XT USB
3 - 18 ba76019e01 12/2012
Variant 2: stack expansion backwards
Preparing the stack
mounting
Fig. 3-9 Preparing the MIQ modules for stack mounting (variant 2)
Mounting the contact
base
Fig. 3-10 Mounting the contact base (variant 2)
1 Remove the covers from the drilled mounting holes (pos. 1 and
3 in Fig. 3-9).
2 Remove the contact cover (pos. 2).
3 Pull off the adhesive label (pos. 4).
4 On the back MIQ module, remove the two countersunk screws
(pos. 5) and swing open the module lid.
5
For stack mounting remove label
and install contact carrier
1 3
2 4
Back Front
MIQ module MIQ module
6
7