YSI IQ SensorNet 2020 XT Terminal - Manual (Page 58)

Installation System 2020 XT USB
3 - 28 ba76019e01 12/2012
whole contact cover. Leave it hanging on the side of the MIQ module.
After removing the terminal, replace the cover again to protect the
contacts.
Fig. 3-19 Docking the terminal component
Configuring the MIQ/
TC 2020 XT as a mobile
terminal
During the commissioning of the MIQ/TC 2020 XT at the
IQ S
ENSOR N ET a query appears asking whether the MIQ/TC 2020 XT
should work as a terminal or controller. Select Terminal: (see section
3.11).
2 Attach the terminal component to the module lid. To do so,
insert the flap on the back of the terminal into the slot on the
door hinge of the MIQ module. Then, pull back the interlocking
lever (pos. 2 in Fig. 3-19), place the terminal completely on the
MIQ module and release the interlocking lever.
3 To protect any inadvertent removal of the terminal component,
the interlocking lever can be fixed in place with the screw (pos.
3 in Fig. 3-19).
3
2