Hach-Lange DR 6000 User Manual - Manual (Page 132)

132
Expanded programs
The count-down starts automatically.
3. Press Close to let the timer run in the background.
Press Cancel to stop the timer.
4. When the timer has finished a sound is emitted.
6.8.4 AQA
The "AQA" menu contains the programs for testing the analytical
quality. For example, this controls the individual working method
with standard solutions or the cross-sensitivities of the analyses
identified by addition solutions, multiple determinations and
dilutions. For a detailed description, refer to
section 6.7.4,
page 123 .
6.8.5 Trends
Use this function to call up a load curve of the stored
measurement values for each parameter or sample location. The
concentration of the corresponding parameter is shown
graphically over time. For a detailed description, refer to
section 5.3.4.1, page 51 .
6.8.6 Carousel insert
This function is shown when an optionally available carousel
insert (sample changer) is used.
There is a carousel for 1 inch rectangular cells and one for
1 cm rectangular cells available.
Additional information can be found in the carousel user manual.
6.8.7 LINK2sc
Link2SC enables the exchange of measurement values between
online process probes and the DR 6000. This enables online data
to be verified and process probes to be corrected as necessary.
The online data is sent to the DR 6000 in a "job file". After the
laboratory measurement values have been produced, the job file
is sent to the controller again for the corresponding probe to be
corrected.
Data transfer is either via memory card or network (LAN). Please
take a precise description from the LINK2sc user manual
(DOC012.xx.90329).