Hach-Lange DR 6000 User Manual - Manual (Page 80)

80
Expanded programs
6.1.1 Program a user method
All input steps and their significance and options are explained in
the following sections.
1. Select New in the "Program Options" menu.
Program Number:
The program number is a specific test number, with which the
program can subsequently be called up from the selection list in
the User Programs menu or the Favorites menu.
2. Use the alphanumeric keypad to enter a program number
between 9000 and 9099. The lowest available number
appears automatically.
3. Press OK.
Note: Should a program number already be assigned to another
user program, the query occurs as to whether the existing program
should be replaced. If you tap on OK, the existing program is
overwritten.
Program Name:
4. Enter a program name via the alphanumeric keypad. The
name can be a maximum of 28 characters long.
5. Press Back to go back to the previous program point or
press Next to continue with the input of the program data.
Program type:
6. Select the required program type ( Table 8 ) and press Next.
7. If the options Single Wavelength ( section 6.1.1.1, page 81 )
or Multi-Wavelength ( section 6.1.1.2, page 82 ) are
selected, define the programming parameters:
• Unit
• Wavelength
• Calculation formula
• Wavelength λx
• Concentration factor Kx
• Concentration solution
• Chemical form
• Calibration equation
For more information on free programming parameters refer to
section 6.1.2, page 88 .