Luminex xPONENT for MAGPIX 4.2 - Manual (Page 60)

• Apply Std/Ctrl Kit - Opens the Select Std/Ctrl Kit dialog box. The dialog box displays the
Std/Ctrl Kit Lot #, Std/Ctrl Kit Name, Expiration, and Manufacturer for the kit. Select a
Std/Ctrl kit from the list and then click OK to close the dialog box. The kit information will
display in the boxes to the right of the Apply Std/Ctrl Kit button. The selected kit must be
associated with the same analyte names. You can also type information by clicking in the
Name, Std/Ctrl Kit Lot #, Expiration, and Manufacturer boxes and typing the
information.
• Assay Standard Information - Displays the selected standard reagents in a list. The list
displays the Reagent, Name, Lot #, Expiration, Manufacturer, and expected
concentration value of each analyte.
NOTE: Click a Reagent column header to re-sort the order from the highest
number standard to standard number one. This is useful for applying
dilutions in which the last standard is the highest standard.
• Apply Std Lot - Opens the Select Lot dialog box.
Select a lot from the list and then click OK to apply the lot.
• Apply Values - Applies a value across or down the Reagent, Name, Lot #, Expiration,
and Analyte fields. Type a value in these fields by double-clicking on them, and then
using one of the two Apply Values arrows to apply that value down or across the list of
analytes.
• Dilution - Contains the following dilution options:
• 1:2 - Halves the standard from each previous iteration.
• 1:10 (Log) - Computes a value of one-tenth of the standard from each previous
iteration.
• 1/2 Log - Creates a 1:3.16 dilution, or half of each 1:10 (Log) from each previous
iteration.
• Apply Dilution - Applies the dilution selected in the Dilution list.
NOTE: The Dilution List and Apply Dilution button are displayed only if a
quantitative analysis has been selected.
NOTE: You can also type a number to set your own dilution factor. It must
be a whole number.
Batches Page
47