Luminex xPONENT for MAGPIX 4.2 - Manual (Page 83)

• Invalidate - Invalidates an entire selected row or cell in the Results table. The selection will
turn red when invalidated. Select the same item and click Validate to remove the
invalidation status.
• Close - Closes the batch and reopens the Saved Batches tab.
Validate Standards
Your xPONENT ® system administrator must give you privileges to validate standards if you
are using the Secure xPONENT package. All standards are assumed to be valid unless
explicitly invalidated.
1. Open the Results page.
2. Open the Saved Batches tab.
3. Click the batch name, then click Open. The Results tab opens.
4. Click the square area next to left of the standard you wish to validate, then click Validate.
Invalidate Standards and Controls
NOTE: It is possible to invalidate or remove a control in data analysis.
However, Luminex does not recommend invalidating controls.
For information on assay controls and guidelines regarding accepting or rejecting control
values, contact the assay kit manufacturer.
To invalidate standards and controls:
1. Open the Results page, then open the Saved Batches tab.
2. Open the Saved Batches tab.
3. Click the batch name, then click Open. The Results tab opens.
4. Click the square area to the left of the well you wish to invalidate, then click Invalidate.
The whole row turns red.
Settings Subtab
Results > Saved Batches > Settings
xPONENT for MAGPIX 4.2 Software User Manual
70