Micromod MOD: Modcell 2050R Users Guide - Manual (Page 144)

IB-23C650
BASIC OPERATION
OPERATION IN MANUAL
This section describes operations for local set-points, remote or multiple set-
points, and A/M ratio bias while the controller is in the manual mode. For
manual ramp/soak and totalizer operations, refer to those operations sections.
Manual Operation with Local Set-Points
The instrument is initially in manual mode with set-point displayed in the lower
engineering display, as indicated by [SPT] in the third status display.
[MAN] indicates that the controller is in
manual mode.
Bottom status display indicates lower
engineering display is showing the
current set-point and its engineering
units label.
DN / UP status display indicates the UP
and DN keys are active and can be
used to adjust the set-point value.
1) Press the scroll key to display the
output in percent in the lower
engineering display.
[OUT] appears in the third status
display.
H or C indicates Heat or Cool if
controller was configured for heat/cool
operation.
DN / UP status display indicates the UP
and DN keys are active and can be
used to adjust the output value in
manual.
138