Micromod MOD: Modcell 2050R Users Guide - Manual (Page 146)

IB-23C650
BASIC OPERATION
Press the scroll key to display the
output in percent in the lower
engineering display.
[OUT] appears in the third status
display.
DN / UP status display indicates the UP
and DN keys are active and can be
used to adjust the output value in
manual.
Press the scroll key again to return the
set-point in the lower engineering
display.
Remote or multiple set-point transfer is
made by pressing the R/L key (press
and release)
[BAL] appears in the third status
display.
For a bumpless set-point transfer,
press the
UP or DN key until the lower
engineering display reaches “0.“
Press scroll to enact the new set-point.
The active set-point may be changed
using the up or down key.
If the active set-point was enabled as “fixed” in the SETPTS MENU, it cannot
be adjusted in the DISPLAYS MENU. Pressing scroll again will select the next
enabled set-point followed by a balance display. Repeat the previous
procedure to balance the set-point, pressing scroll to enact the new set-point.
140