Micromod MOD: Modcell 2050R Users Guide - Manual (Page 92)

IB-23C650
SETUP
Table 8. Set-Point Setup Menu
Step Step Description
Top
Display
1 Set-Point Menu.
UP moves to RELAYS **MENU**.
DN moves to RAMPSOAK **MENU** if ramp/soak
is enabled, or to TOTALIZE **MENU** if
integrator/totalizer is enabled, or to ALARMS
**MENU** otherwise.
SCRL to begin setup at Step 2.
SETPTS
2 Local Set-Point.
UP begins set-point configuration at Step 2.1.
SCRL to advance to Step 3.
LOC SETP
2.1 Local Set-Point Fixed.
UP or DN selects YES or NO.
SCRL to advance to Step 2.2.
LOC SETP
2.2 Local Set-Point High Limit.
UP or DN sets value.
SCRL to advance to Step 2.3.
LOC SETP
2.3 Local Set-Point Low Limit.
UP or DN sets value.
SCRL to advance to Step 2.4.
LOC SETP
2.4 Local Set-Point Initial Value.
UP or DN sets value.
SCRL to advance to Step 3.
LOC SETP
3 Local Set-Point 2.
UP begins set-point 2 configuration at Step 3.1.
SCRL to advance to Step 4.
SETPT 2
3.1 Local Set-Point 2 Enable.
UP or DN selects YES or NO.
SCRL to advance to Step 3.2.
SETPT 2
3.2 Local Set-Point 2 Fixed.
UP or DN selects YES or NO.
SCRL to advance to Step 3.3.
SETPT 2
3.3 Local Set-Point 2 High Limit.
UP or DN sets value.
SCRL to advance to Step 3.4.
SETPT 2
86