Micromod MOD: Modcell 2050R Users Guide - Manual (Page 46)

IB-23C650
SETUP
Table 1. Base Configuration
Step Step Description
Top
Display
11 Totalizer Enable.
UP selects YES or DN selects NO.
SCRL advances to Step 12.
TOTALIZE
12 RS-485 Communications Enable.
(Requires Option Board)
UP selects YES or DN selects NO.
SCRL advances to Step 13.
RS-485
13 Tune Password.
UP or DN sets tune password value (value must
be other than zero to lock configuration menus in
Step 19 ).
SCRL advances to Step 14.
TUNE
14 Configure Password.
UP or DN sets configure password value (value
must be other than zero to lock configuration
menus in Step 19 ).
SCRL advances to:
Step 20 if you don’t have configuration access
with a non-zero password, or
Step 15 if you have config. access with a non-
zero password and a bad check sum was
found at most recent power up or check
summing is currently off, or
Step 16 otherwise.
CONFIG
15 Checksum the database.
UP selects YES or DN selects NO.
SCRL advances to:
Step 16 from NO, or
Step 15.1 from YES.
CHK SUM
15.1 Are You Sure You Want to Stop Check-
summing the Database?
UP selects YES or DN selects NO.
SCRL advances to Step 16.
ARE YOU
40