Micromod MOD: Modcell 2050R Users Guide - Manual (Page 44)

IB-23C650
SETUP
Table 1. Base Configuration
Step Step Description
Top
Display
5.5.5 Repeat Calibration.
UP selects YES or DN selects NO.
SCRL advances to:
Step 6 from NO, or
Step 5.5.1 from YES.
Note: Valve operation should be checked by
returning to the operation Displays and controlling
the valve in manual.
REPEAT
6 Hold Power-Up Message.
UP selects YES or DN selects NO.
SCRL advances to Step 7.
HOLD PWR
7 Power-Up Mode.
UP or DN selects power-up mode value.
SCRL advances to:
Step 10 if output type is on/off, or
Step 8 otherwise.
POWER UP
8 Auto/Manual Ratio Bias Station Enable.
UP selects YES or DN selects NO.
SCRL advances to:
Step 11 from YES, or
Step 10 if output type is heat/cool, or
Step 9 otherwise.
RAT BIAS
9 Auto Tune Enable.
UP selects YES or DN selects NO.
SCRL advances to Step 10.
AUTOTUNE
10 Ramp-Soak Enable.
UP selects YES or DN selects NO.
SCRL advances to Step 11.
RAMPSOAK
38