Gentec-EO MAESTRO - Manual (Page 48)

MAESTRO User’s Manual Revision 8.1 47
Power only dd:hh:mm:ss
00:00:00:00 days, followed by hours, minutes and seconds.
The MAESTRO automatically clears and
recalculates the statistics at the end of each
sample period unless you manually stop it.
Duration
Energy only
Integers
Number of
pulses
Number of pulses for which samples are reported
(to the display and output).
The MAESTRO automatically clears and
recalculates the statistics at the end of each
sample period unless you manually stop it.
10000 pulses
File name Alphanumeric
characters
Output file
name
Use the displayed keyboard to enter the new
output file name with an extension (.csv, .txt or
.dat). Note that you must enter a file name to be
able to start an acquisition.
Use the Add button to increment the file
name. If no name was entered, the Add button
automatically adds a file name.
noname_0001.txt
Time Stamp Yes
No
To have a time stamp appear with the data,
touch the associated check box.
Selecting the check box writes a time stamp with
each data point. This is a relative time stamp that
always begins with zero.
Note that, with the time stamp, the maximum
sampling rate without missing points is 1.3 kHz
instead of 2 kHz without time stamp.
No
To start the acquisition you must return to the display window in dual or single mode. Touch the DATA
ACQUISITION button on the Display Parameters menu bar and then touch Start (refer to section
2.4.3.1). The MAESTRO begins storing data according to your Data Sampling settings. The Stop
command stops the data recording before the end of the acquisition total duration. Even if the acquisition
is stopped, the MAESTRO will continue to provide measurements to the display. If you want to be able to
open the file in Excel use .csv in your file name extension.