Gentec-EO MAESTRO - Manual (Page 85)

MAESTRO User’s Manual Revision 8.1 84
*SWA
Set Personal Wavelength Correction
This command is used to specify the wavelength being used on the detector. The
EEPROM in the detector contains measured spectral data for a wide range of wavelengths. If the
wavelength input by the user is different from the predefined list of wavelengths in the device, a
custom value is interpolated. Specifying zero as a wavelength or providing an out-of-bound value
as a parameter restores the default settings. A valid value is set between the lowest and highest
wavelengths supported by the device, and it should not be a floating point value.
Text Command Parameters Return
SWA Wavelength ACK
Default: Calibration wavelength, (typically 1064 nm)
*SMU
Set Multiplier
This command is used to set the multiplier’s value. Note that the MAESTRO only allows
one multiplier instead of 2 unlike the SOLO2. This means that only Multiplier 1 can be set.
Text Command Parameters Return
SMU Multiplier 1 +, <Multiplier value> ACK
The following example sets multiplier 1 to 3.3.
Example Response from MAESTRO
Text Command: *SMU <space> 1<space> 3.3
<enter>
ACK <CR> <LF>
*SOU
Set Offsets
This command is used to set the offset’s value. . Note that the MAESTRO only allows
one offset instead of 2 unlike the SOLO2. This means that only Offset 1 can be set.
Text Command Parameters Return
SOU Offset 1 + <Offset value> ACK
The following example sets offset 1 to 1.5 milli.
Example Response from MAESTRO
Text Command: *SOU <sapce> 1 <space> 0.0015
<enter> ACK <CR> <LF>
The other option available is the Zero-offset. The Zero-offset operation is done first,
before those of the Multipliers and Offsets