Gentec-EO MAESTRO - Manual (Page 78)

MAESTRO User’s Manual Revision 8.1 77
3.4.4 Legacy monitor serial commands
The MAESTRO has the ability to emulate the Serial Commands of our legacy monitors, Set the
MAESTRO In home/Set device/Serial Commands/ to SOLO2 Serial Compatibility (refer to section
2.4.1.3). You can make it the default setting when the MAESTRO boots up in the same window.
Supported Legacy Monitor:

SOLO2, The SOLO2 binary commands ’ are not supported.
3.4.4.1 Emulated SOLO2 Serial commands
SOLO2 SERIAL COMMAND FORMAT
All text commands must begin with a trig character (*) and must end with a line-feed or a
carriage-return. All parameters must be separated by one or many spaces. The characters
do not have to be capitals and mixed case is ok. Replies to all text mode commands are also in
text mode, and end with a carriage-return and line-feed.