Gentec-EO MAESTRO - Manual (Page 67)

MAESTRO User’s Manual Revision 8.1 66
Continuous transmission of data
This command is used to send data to the serial port according to the data sampling setting. The
maximum transfer speed is 200Hz.
Text Command Parameters Return
CAU None Data in ASCII
Stop the CAU Command
This command is used to stop the real time transfer enabled by the CAU Command.
Text Command Parameters Return
CSU None
Query New Value Ready
This command is used to check whether a new value is available from the device. Though
optional, its use is recommended when used with single pulse operations.
Text Command Parameters Return
NVU Available/ Not Available <CR> <LF>
1/0
Example Response from MAESTRO
Text Command: *NVU <enter> New Data Not Available <CR> <LF>
Note that the Query Current Value and Query Statistic Data commands will return the current
values from the device even if they have not been updated since the last query.
Get the Laser frequency
This command is used to get the laser frequency.
Text Command Parameters Return
GRR None Data in ASCII
Set the joulemeter binary mode
This command is used to set the monitor in binary or ASCII mode. Refer to section 3.4.2 for the
MAESTRO binary mode description.