Gentec-EO MAESTRO - Manual (Page 79)

MAESTRO User’s Manual Revision 8.1 78
DISPLAY COMMANDS
Command name Command Description
Set Scale SSA Manually set scale.
Set High Resolution Display SHL Change to high resolution display
Set dBm display DBU Change the on-screen display to dBm
MEASUREMENT COMMANDS
MEASUREMENT DATA ACQUISITION
Command name Command Description
Query Current Value CVU Get the value currently displayed on the screen.
Query Statistic Data VSU Read statistics data.
Set Logging Start /Stop LOG Start storing data in monitor (PCMCIA card or EEPROM).
Download points CAU Send the values in ASCII to the serial port with the data
sampling setting.
Stop the CAU Command CSU Stop the CAU Command
Query New Value Ready NVU Determine if new reading is available.
Set Analog output ANO Enable or disable analog output
MEASUREMENT SETUP
Command name Command Description
Set Personal Wavelength Correction SWA Specify the wavelength.
Set Multipliers SMU Set the value of the multipliers.
Set Offsets SOU Set the value of the offsets.
Set Trigger Level TLA Set the internal trigger level when measuring pulse energy.
MEASUREMENT CONTROL
Command name Command Description
Enable Statistics ESU Start, stop or reset the statistic calculations.
Set Energy Mode SCA Turn energy mode on or off.
Set Anticipation EAA Turn power measurement anticipation on or off.
Set Zero Offset EOA Zero the reading to remove noise.
INSTRUMENT AND DETECTOR INFORMATION COMMANDS
Command name Command Description
Query version VER Get firmware version of the monitor.
Query Head Name HEA Get model name of the detector head.
Query Battery Power BAT Get state of remaining battery power.
INSTRUMENT CONTROL COMMANDS
Command name Command Description
Set Backlight BKL Turn the display backlight on or off.
COMMUNICATIONS COMMANDS
Command name Command Description
Test Communication KPA Test communication between monitor and PC.