Gentec-EO MAESTRO - Manual (Page 70)

MAESTRO User’s Manual Revision 8.1 69
Zero Offset
This command subtracts the current value from all future measurements the moment the
command is issued to set a new zero point.
Text Command Parameters Return
SOU None
Clear Zero Offset
This command undoes the Zero Offset command to set the zero point at zero.
Text Command Parameters Return
COU None
Set diode zero.
This command subtracts the current value for all available scales from all future measurements
the moment the command is issued to set a new zero point for a photodiode only.
Text Command Parameters Return
SDZ None DONE
Set User Multipliers
This command is used to set the value of the multipliers. The default value is 1.
Text Command Parameters Return
MUL 8 characters numeral value
The following example sets multiplier = 33
Example Response from MAESTRO
Text Command: *MUL3300000
Or
*MUL3.3000e3
Get User Multiplier
This command returns the MAESTRO’s correction multiplier value.
Text Command Parameters Return
GUM None Current multiplier value