Gentec-EO MAESTRO - Manual (Page 27)

MAESTRO User’s Manual Revision 8.1 26
Fig. 2-11 The Set Measure menu window
2.4.2.1 Wavelength
The Wavelength menu is used to select the proper wavelength at which the detector is used. It applies a
correction to adjust for the variation in responsivity at different wavelengths. Pre-programmed
wavelength correction factors dedicated to each detector head are available and automatically loaded
from the detector EEPROM, for version 5 and higher detector heads. When a new detector is plugged in,
the calibration wavelength is the default selection.
To change the wavelength, select the appropriate wavelength from the Wavelength menu. For
photodiodes, left and right arrows will allow you to access all the available wavelengths. Once the
wavelength is set, touch the OK button to save the changes or touch the cancel button to
ignore the changes.