Gentec-EO MAESTRO - Manual (Page 89)

MAESTRO User’s Manual Revision 8.1 88
3.4.4.2 Error Messages for SOLO2 Serial mode
# Error Comment
1 Command not found Command is invalid.
2 Invalid Parameter The parameter value is out of valid range, or not
of expected type (text, numeric, flag).
3 Not Enough Parameters The expected number of parameters should
always be sent.
4 Head is not available Verify that the detector’s DB15 connector is fully
engaged with the meter.
5 Scale setting not available for specified head Refer to the Scale table in the Set Scale
command.
6 Anticipation is not available Make sure that the detector is in power-reading
mode.
7 PWC is not available Make sure that the detector head version
supports Personal Wavelength Correction
8 Invalid Command: Too long. The command must not be over 255 characters
long.
9 Too many Parameters The correct number of parameters must be sent
to the device.
10 Energy mode is not available with current head Energy Mode works only with 818P Series High
Power Detectors.
11 Option only available with photodiode Make sure the head is a photodiode.
12 Attenuator not available with current head Make sure the head support attenuator.