Gentec-EO MAESTRO - Manual (Page 94)

MAESTRO User’s Manual Revision 8.1 93
7 APPENDIX B
7.1 Recycling and separation procedure.
This section is used by the recycling center when the monitor reaches its end of life. Breaking the
calibration seal or opening the monitor will void the MAESTRO warranty.
The complete Monitor contains
1 Monitor
1 Power supply (not manufactured by Gentec-eo)
1 USB cable
1- Battery pack
1 Instruction manual
1 Calibration certificate
1 Software cdrom
7.2 Separation:
Paper : Manual and certificate.
Plastic: Bottom monitor enclosure, LCD enclosure.
Plastic and rubber: Top monitor Enclosure.
Wires: USB cable and power supply plug.
NimH batteries: in the Battery compartment at the back.
Liquid crystal display.
Printed circuit board: inside the monitor.
7.3 Dismantling procedure:
Remove the DB15 post using pliers.
Remove the 4 screw on the bottom of the monitor using a Philips screwdriver.
Disconnect the Battery and LCD.