LevelOne FGL-2870 - Manual (Page 189)

General Security Measures
3-135
3
Binding a Port to an Access Control List
After configuring the Access Control Lists (ACL), you can bind the ports that need to
filter traffic to the appropriate ACLs. You can assign one IP/IPv6 access list and one
MAC access list to any port.
Command Usage
• Each ACL can have up to 64 rules.
• This switch supports ACLs for ingress filtering only.
• You only bind one ACL to any port for ingress filtering.
Command Attributes
• Port – Fixed port or SFP module. (Range: 1-28/52)
• IP – Specifies the IP ACL to bind to a port.
• MAC – Specifies the MAC ACL to bind to a port.
• IPv6 – Specifies the IPv6 ACL to bind to a port.
• IN – ACL for ingress packets.
• Trunk – Indicates if a port is a member of a trunk. To create trunks and select port
members, see "Creating Trunk Groups" on page 3-160.
Web – Click Security, ACL, Port Binding. Mark the Enabled check box for the port
you want to bind to an ACL for ingress traffic, select the required ACL from the
drop-down list, then click Apply.
Figure 3-81 Configuring ACL Port Binding