LevelOne FGL-2870 - Manual (Page 454)

Command Line Interface
4-88
4
snmp-server
This command enables the SNMPv3 engine and services for all management clients
(i.e., versions 1, 2c, 3). Use the no form to disable the server.
Syntax
[no] snmp-server
Default Setting
Enabled
Command Mode
Global Configuration
Example
ATC Trap Commands
snmp-server
enable port-traps atc
broadcast-alarm-fire
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control
IC (Port) 4-242
snmp-server
enable port-traps atc
multicast-alarm-fire
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control
IC (Port) 4-243
snmp-server
enable port-traps atc
broadcast-alarm-clear
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered
IC (Port) 4-243
snmp-server
enable port-traps atc
multicast-alarm-clear
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered
IC (Port) 4-244
snmp-server
enable port-traps atc
broadcast-control-apply
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port) 4-244
snmp-server
enable port-traps atc
multicast-control-apply
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port) 4-245
snmp-server
enable port-traps atc
broadcast-control-release
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered
and the release timer expires
IC (Port) 4-245
snmp-server
enable port-traps atc
multicast-control-release
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been triggered
and the release timer expires
IC (Port) 4-246
Console(config)#snmp-server
Console(config)#
Table 4-21 SNMP Commands (Continued)
Command Function Mode Page