LevelOne FGL-2870 - Manual (Page 449)

System Management Commands
4-83
4
cluster member
This command configures a Candidate switch as a cluster Member. Use the no form
to remove a Member switch from the cluster.
Syntax
cluster member mac-address mac-address id member-id
no cluster member id member-id
• mac-address - The MAC address of the Candidate switch.
• member-id - The ID number to assign to the Member switch. (Range: 1-36)
Default Setting
No Members
Command Mode
Global Configuration
Command Usage
• The maximum number of cluster Members is 36.
• The maximum number of cluster Candidates is 100 .
Example
rcommand
This command provides access to a cluster Member CLI for configuration.
Syntax
rcommand id member-id
member-id - The ID number of the Member switch. (Range: 1-36)
Command Mode
Privileged Exec
Command Usage
• This command only operates through a Telnet connection to the Commander
switch. Managing cluster Members using the local console CLI on the
Commander is not supported.
• There is no need to enter the username and password for access to the
Member switch CLI
.
Example
Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5
Console(config)#
Vty-0#rcommand id 1
CLI session with the FGL-2870 is opened.
To end the CLI session, enter [Exit].
Vty-0#