Displaying interface settings for sta – LevelOne FGL-2870 User Manual

Page 252

Advertising
background image

Configuring the Switch

3-198

3

CLI – This example enables Spanning Tree Protocol, sets the mode to RSTP, and
then configures the STA and RSTP parameters.

Displaying Interface Settings for STA

The STA Port Information and STA Trunk Information pages display the current
status of ports and trunks in the Spanning Tree.

Field Attributes
Spanning Tree – Shows if STA has been enabled on this interface.
BPDU Flooding – Shows if BPDUs will be flooded to other ports when spanning

tree is disabled globally on the switch or disabled on a specific port.

STA Status – Displays current state of this port within the Spanning Tree:

Discarding - Port receives STA configuration messages, but does not forward

packets.

Learning - Port has transmitted configuration messages for an interval set by

the Forward Delay parameter without receiving contradictory information. Port
address table is cleared, and the port begins learning addresses.

Forwarding - Port forwards packets, and continues learning addresses.

The rules defining port status are:
- A port on a network segment with no other STA compliant bridging device is

always forwarding.

- If two ports of a switch are connected to the same segment and there is no other

STA device attached to this segment, the port with the smaller ID forwards
packets and the other is discarding.

- All ports are discarding when the switch is booted, then some of them change

state to learning, and then to forwarding.

Forward Transitions – The number of times this port has transitioned from the

Learning state to the Forwarding state.

Designated Cost – The cost for a packet to travel from this port to the root in the

current Spanning Tree configuration. The slower the media, the higher the cost.

Designated Bridge – The bridge priority and MAC address of the device through

which this port must communicate to reach the root of the Spanning Tree.

Console(config)#spanning-tree

4-269

Console(config)#spanning-tree mode mstp

4-270

Console(config)#spanning-tree priority 45056

4-273

Console(config)#spanning-tree hello-time 5

4-271

Console(config)#spanning-tree max-age 38

4-272

Console(config)#spanning-tree forward-time 20

4-271

Console(config)#spanning-tree pathcost method long

4-274

Console(config)#spanning-tree transmission-limit 4

4-274

Console(config)#spanning-tree mst configuration

4-275

Console(config-mstp)#revision 1

4-277

Console(config-mstp)#name R&D

4-277

Console(config-mstp)#max-hops 30

4-278

Console(config-mstp)#

Advertising