Spanning-tree mode – LevelOne FGL-2870 User Manual

Page 636

Advertising
background image

Command Line Interface

4-270

4

spanning-tree mode

This command selects the spanning tree mode for this switch. Use the no form to
restore the default.

Syntax

spanning-tree mode {stp | rstp

|

mstp}

no spanning-tree mode

stp - Spanning Tree Protocol (IEEE 802.1D)
rstp - Rapid Spanning Tree Protocol (IEEE 802.1w)
mstp - Multiple Spanning Tree (IEEE 802.1s)

Default Setting

rstp

Command Mode

Global Configuration

Command Usage

• Spanning Tree Protocol

Uses RSTP for the internal state machine, but sends only 802.1D BPDUs.
- This creates one spanning tree instance for the entire network. If multiple

VLANs are implemented on a network, the path between specific VLAN
members may be inadvertently disabled to prevent network loops, thus
isolating group members. When operating multiple VLANs, we recommend
selecting the MSTP option.

• Rapid Spanning Tree Protocol

RSTP supports connections to either STP or RSTP nodes by monitoring
the incoming protocol messages and dynamically adjusting the type of
protocol messages the RSTP node transmits, as described below:
- STP Mode – If the switch receives an 802.1D BPDU after a port’s migration

delay timer expires, the switch assumes it is connected to an 802.1D bridge
and starts using only 802.1D BPDUs.

- RSTP Mode – If RSTP is using 802.1D BPDUs on a port and receives an

RSTP BPDU after the migration delay expires, RSTP restarts the migration
delay timer and begins using RSTP BPDUs on that port.

• Multiple Spanning Tree Protocol

- To allow multiple spanning trees to operate over the network, you must

configure a related set of bridges with the same MSTP configuration,
allowing them to participate in a specific set of spanning tree instances.

- A spanning tree instance can exist only on bridges that have compatible

VLAN instance assignments.

- Be careful when switching between spanning tree modes. Changing modes

stops all spanning-tree instances for the previous mode and restarts the
system in the new mode, temporarily disrupting user traffic.

Advertising