LevelOne FGL-2870 - Manual (Page 617)

Link Aggregation Commands
4-251
4
Example
The following shows LACP enabled on ports 11-13. Because LACP has also been
enabled on the ports at the other end of the links, the show interfaces status
port-channel 1 command shows that Trunk 1 has been established.
lacp system-priority
This command configures a port's LACP system priority. Use the no form to restore
the default setting.
Syntax
lacp {actor | partner} system-priority priority
no lacp {actor | partner} system-priority
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate link.
• priority - This priority is used to determine link aggregation group (LAG)
membership, and to identify this device to other switches during LAG
negotiations. (Range: 0-65535)
Default Setting
32768
Console(config)#interface ethernet 1/11
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/12
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/13
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#exit
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port Type: 100TX
Mac Address: 00-12-CF-12-34-72
Configuration:
Name:
Port Admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full
Flow Control: Disabled
VLAN Trunking: Disabled
Port Security: Disabled
Max MAC Count: 0
Giga PHY mode: Auto preferred master
Current Status:
Created by: LACP
Link Status: Up
Port Operation Status: Up
Operation Speed-duplex: 100full
Flow Control Type: None
Member Ports: Eth1/11, Eth1/12, Eth1/13,
Console#