LevelOne FGL-2870 - Manual (Page 95)

Basic Configuration
3-41
3
CLI – Enter the IP address of at least one SMTP server, set the syslog severity level
to trigger an email message, and specify the switch (source) and up to five recipient
(destination) email addresses. Enable SMTP with the logging sendmail command
to complete the configuration. Use the show logging sendmail command to display
the current SMTP configuration.
Resetting the System
This feature restarts the system. You can reboot the system immediately, or you can
configure the switch to reset after a specified amount of time.
Command Attributes
• Hours – Specifies the amount of hours to wait, combined with the minutes, before
the switch resets. (Range: 0-576; Default: 0)
• Minutes – Specifies the amount of minutes to wait, combined with the hours,
before the switch resets. (Range: 1-34560; Default: 0)
• Reset – Resets the switch after the specified time. If the hour and minute fields are
blank, then the switch will reset immediately.
• Refresh – Refreshes the countdown timer of a pending delayed reset.
• Cancel – Cancels a pending delayed reset.
Note: To rimmediately restart the switch, enter “0” in both the Hours and Minutes fields,
and click Reset.
Console(config)#logging sendmail host 192.168.1.4
4-63
Console(config)#logging sendmail level 3 4-64
Console(config)#logging sendmail source-email
[email protected]
4-64
Console(config)#logging sendmail destination-email
[email protected] 4-65
Console(config)#logging sendmail 4-65
Console(config)#exit
Console#show logging sendmail
4-65
SMTP servers
-----------------------------------------------
1. 192.168.1.4
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. [email protected]
SMTP source email address: [email protected]
SMTP status: Enabled
Console#