LevelOne FGL-2870 - Manual (Page 410)

Command Line Interface
4-44
4
Default Setting
None
Command Mode
Global Configuration
Command Usage
• This command is used in conjunction with the upgrade opcode auto
command (page 4-42) to facilitate automatic upgrade of new operational code
stored at the location indicated by this command.
• The name for the new image stored on the FTP/TFTP server must be
FGL-2870.bix. However, note that file name is not to be included in this
command.
• When specifying a TFTP server, the following syntax must be used, where
filedir indicates the path to the directory containing the new image:
tftp://192.168.0.1[/filedir]/
• When specifying an FTP server, the following syntax must be used, where
filedir indicates the path to the directory containing the new image:
ftp://[username[:password@]]192.168.0.1[/filedir]/
If the user name is omitted, “Anonymous” will be used for the connection. If
the password is omitted a null string (“”) will be used for the connection.
Example
This shows how to specify a TFTP server where new code is stored.
This shows how to specify an FTP server where new code is stored.
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Console(config)#upgrade opcode path tftp://192.168.0.1/sm24/
Console(config)#
Console(config)#upgrade opcode path ftp://admin:[email protected]/sm24/
Console(config)#
Table 4-13 Line Commands
Command Function Mode Page
line Identifies a specific line for configuration and starts the line
configuration mode
GC 4-45
login Enables password checking at login LC 4-46
password Specifies a password on a line LC 4-47
timeout login
response
Sets the interval that the system waits for a user to log into the
CLI
LC 4-48
* These commands only apply to the serial port.