Yokogawa IR200 - Manual (Page 31)

5 - 2
IM 11G02M01-01E
Fig. 5-2
5.2 Overview of display and operation panel
• Measurement mode
•
Measurement mode
•
User mode
•
User mode
1. Changeover of Range
2. Setting about Calibration
3. Alarm Setting
4. Setting of Auto Calibration
5. Setting of Auto zero
calibration
6. Setting of Peak Alarm
7. Parameter Setting
• Changeover of
Range
•
Selection of items
Calibration value
Calibration gas
About Zero calibration
About Calibration range
Auto calibration component
*1
ZERO Calibration
SPAN Calibration
•
Selection of items
Current time : Current time setting
Key lock : Key lock ON/OFF
Remote range : Remote range ON/OFF
Output hold : ON/OFF
Reset Average : Average value resetting
output
Response time
: Response time (filter)
Average period : Average time setting
To maintenance : Maintenance mode
mode (entry of password)
SPAN
ZERO
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
MODE
•
Setting about
Calibration
•
Alarm Setting
•
Setting of Auto
Calibration
•
Setting of Auto
zero calibration
•
Setting of
Peak Alarm
•
Parameter
Setting
*1) The screen configuration depends upon the display channel.
When channel 5 or later is displayed on the screen, scroll the
screen by using the UP or DOWN key.
•
Selection of items
Start time
Cycle
Flow time
Auto calibration ON/OFF
Auto zero calibration stop
•
Selection of items
Start time
Cycle
Flow time
ON/OFF
Auto zero calibration stop
•
Selection of items
Peak alarm ON/OFF
Peak alarm value
Peak alarm count
Hysteresis
*2) Peak alarm is displayed
only when specified as an
option.
*3) "Calibration gas" is displayed if NO or SO 2 is
included in components to be analyzed.