Yokogawa IR200 - Manual (Page 57)

6 - 22
IM 11G02M01-01E
• Zero calibration
Example
In case where setting the auto calibration components (see Item 6.2.5) to
“CH1: enable” and “CH2: enable”.
A message, “Zero calibration” blinks
at CH1 and CH2.
“Auto Zero Calibration” screen
During auto zero calibration, any key operation is not permitted other than operations such
as key lock ON/OFF and “Forced Stop of Auto Zero Calibration”.
When the key lock is set at “ON”, even the “Forced Stop of Auto Zero Calibration” cannot be used.
To stop “Auto Zero Calibration” forcedly, set the key lock to “OFF” and then execute
“Stop Auto Zero Calibration”.
Caution