Yokogawa IR200 - Manual (Page 43)

6 - 8
IM 11G02M01-01E
1. During measurement, press the
MODE
key
to display the User mode.
2. Point the cursor to “Setting about Cali-
bration” by pressing the or key.
Press the
ENT
key.
3. In the “Setting about Calibration” screen
that appears, point the cursor to “About
Calibration Range” by pressing the
or
key. Press the
ENT
key.
4. In the “Calibration Range CH Selection”
screen that appears, point the cursor to
the CH you want to set by pressing the
or key. Press the
ENT
key.
( )
ENT
( )
ENT
MODE
( )
ENT
6.2.4 Setting of calibration range
This mode is used to set if the range of each CH (component) at the zero and span calibration
(manual calibration or auto calibration) should be calibrated with a single range or 2 ranges.