Festo Контроллер позиционирования CPX-CMAX - Manual (Page 33)

2. Fitting and pneumatic installation
2−3
Festo P.BE−CPX−CMA X−SYS−EN en 0908NH
2.1 General notes on mounting and installation
Information about mounting the CPX terminal can be found in
the CPX system description (P.BE−CPX−SYS−..).
Note
Using components that have not been approved for operĆ
ation with the CMAX may lead to malfunctions.
Use only the special matching components from Festo for
setting up and wiring the system.
When mounting the components, also observe the mounting
instructions in the operating instructions supplied and the
instructions in this chapter.
Only then can you guarantee trouble−free operation.
Section 2.4
Section 2.6.3
Section 2.2
Section 2.6.1
Section 2.6.2
Section 2.3.4
Section 2.6.5
Section 2.5
Section 2.3
Section 2.6.4
Fig. 2/1: Overview of mounting and pneumatic installation