Festo Контроллер позиционирования CPX-CMAX Instruction Manuals and User Guides
We have 2 Instruction Manuals and User Guides for Контроллер позиционирования CPX-CMAX Festo
Manuals
| Recognized languages: | English |
|---|---|
| Pages: | 176 |
| Size: | 2.69 MB |
Show table of contents
Read manual
Document Outline
- Contents
- Intended use
- Safety note
- Target group
- Service
- Required software versions for the CPX nodes
- Important user instructions
- Notes on this description
- Glossary
- CMAX system overview
- Fitting and pneumatic installation
- Electrical installation
- Commissioning
- Diagnostics and error handling
- Technical appendix
| Recognized languages: | English |
|---|---|
| Pages: | 446 |
| Size: | 2.75 MB |
Show table of contents
Read manual
Document Outline
- Contents
- Intended use
- Safety instructions
- Target group
- Service
- Important user instructions
- Information about the version
- Glossary
- CPX terminal configuration and FHPP overview
- I/O data and sequence control
- Drive functions
- Faults and diagnostics
- Parameter
- Contents
- 5.1 General parameter structure of the CMAX
- 5.2 Access protection
- 5.3 Default values
- 5.4 Description of the parameters
- 5.4.1 Overview of parameters
- 5.4.2 Device data
- 5.4.3 Diagnostic memory
- 5.4.4 Process data
- 5.4.5 Record list
- 5.4.6 Project data
- 5.4.7 Setpoint values for jog mode
- 5.4.8 Direct operating mode: Positioning
- 5.4.9 Direct operating mode: Force control
- 5.4.10 Parameters of the default values
- 5.4.11 Drive configuration
- 5.4.12 Application settings
- 5.4.13 Controller data of position controller
- 5.4.14 Force controller data
- 5.4.15 Identification
- 5.4.16 System data
- Parametrisation
- Notes on commissioning and service
- Basic controlling principles
- Contents
- B.1 CMAX system of measurement units
- B.2 Dimension reference system for pneumatic drives
- B.3 Drives and measuring systems
- B.4 Taking into account the load
- B.5 Basic information on position control
- B.6 Optimisation of the mechanical structure and the pneumatic installation
- B.7 Optimisation of the controller
- B.8 Basic principles of force control/standstill control
- B.8.1 Influence of the mass on force control
- B.8.2 Influence of the mass on standstill control
- B.8.3 Behaviour of the force control
- B.8.4 Behaviour of standstill control
- B.8.5 Individual value mode
- B.8.6 Position control during a force task
- B.8.7 Force ramp
- B.8.8 Controller amplifications
- B.8.9 Influence of the static identification on force control
- B.8.10 Monitoring function
- B.9 Notes on application, special operating statuses
- Configuration with CPX node
- Index