Konica Minolta bizhub PRESS C8000e - Manual (Page 134)

bizhub PRESS C8000 4-39
4.10 Adjusting Color Balance: Color Balance 4
3
Press [Color Balance] on the Quality Adjustment Screen.
The Color Balance Screen will be displayed.
4
Position the original.
% Prepare an original for adjusting Color Balance, and position it into the ADF or on the original glass.
5
Select the color and density area to be adjusted.
% Check the high, middle, and low density areas of the original, then select the desired density area
of the color to be adjusted.
% To adjust the whole density area, select [All] of that color.
6
Adjust the color level in selected density area.
Use [ +] and [,] to specify the desired level within the range from -10 to +10.
% Select [0] to resume the standard level.
% Press [Default Set] to resume the standard level and return to the Quality Adjustment Screen.
% Proceed to step 7 if a sample copy is desired to check the adjustment result.
% To complete the adjustment, press [OK] and proceed to step 8.
7
Output a sample copy.
After setting the desired adjustment level, press [Adj. Proof Copy] on the Quality Adjustment Screen,
[Adj. Proof Copy] on the Color Balance Screen, or Proof Copy on the control panel. Check the adjust-
ment result with output image.
% Repeat steps from 3 to 7 until the desired result is obtained.
8
Press [Close] on the Quality Adjustment Screen.
The Copy Screen will be restored. The [Color Balance] indication can be found under [Quality Adj.] on
the Copy Screen.