Konica Minolta bizhub PRESS C8000e - Manual (Page 363)

bizhub PRESS C8000 10-55
10.9 [03 Administrator Setting] - [01 System Setting] 10
9
Press [Start] on the screen. The current data of YMCK will be updated.
NOTICE
Since the machine does not determine the adjustment data to be effective or not for the first scanning,
the message [Completed normally] will not be displayed. Press [Start] twice or more to repeat scanning
until the message [Completed normally] is displayed.
NOTICE
If an error code (Error 1, 2, or 10) is displayed, check that the test pattern is positioned properly.
If any other error code is displayed, please contact your service representative.
10
Check that the message [Completed normally] is displayed.
11
If any message other than [Completed normally] is displayed, repeat the steps from 6 to 10.
12
Press [Return] to restore the Quality Adjustment Menu Screen.
10.9.13 [05 Expert Adjustment] - [07 Quality Adjustment] - [03 Printer Gamma Sensor
Adj.]
The printer gamma correction is periodically and automatically made on this machine. The automatic gamma
correction uses an IDC sensor to scan the pattern on the transfer belt. Should the IDC sensor be change in
characteristics, the automatic gamma correction may not be performed properly. The printer gamma sensor
adjustment allows you to correct the IDC sensor using the scanner, in order to make the gamma correction
properly.
NOTICE
Make this adjustment after completing the Gamma Automatic Adjustment.
NOTICE
Please use plain paper or white paper for color printing in this adjustment. Using colored paper cannot make
this adjustment properly, affecting the color of output test pattern.
NOTICE
To restore the factory default data, press [Reset Adj. Data] to reset it.
NOTICE
This adjustment should be made on the machine with ADF equipped. Without the ADF equipped, this ad-
justment is unavailable.