Konica Minolta bizhub PRESS C8000e User Manual
Page 259
bizhub PRESS C8000
7-27
7.3
Editing Hold Job: Job Edit
7
-
The trim margin indicated by the corner crop mark can be specified from 0.1 mm to 20 mm. The default
setting is 3 mm.
-
The size of the corner crop mark is 5 mm in each projection. Changing this size is unavailable.
-
You can make the setting to eliminate the center crop mark.
-
The type of the center crop mark is a cross shape only. The line width is approximately 0.1 mm.
-
The print position of the center crop mark can be specified on the Utility Menu Screen. See page 10-35
for details.
-
The size of the center crop mark is 4 mm in length and 6 mm in width. Changing this size is unavailable.
-
The print position of the corner crop mark and center crop mark can be offset within the range from -
20 mm (inward) to +20 mm (outward) in 0.1 mm increment for both X-coordinate and Y-coordinate. The
default setting is 0.0 mm.
-
Select either both sides or the front side only for the print side of the corner crop mark and center crop
mark in duplex printing.
-
Specify whether or not to synchronize the print position of the corner crop mark and center crop mark
with Page Margin.
1
Press [JOB LIST] tab to display the Job List Screen.
2
Press [Hold Job].
The Hold Job Screen will be displayed.
3
Select the file to be printed with crop marks on the Hold Job Screen.
4
Press [Job Ticket].
The Job Ticket Edit Screen will be displayed.
5
Press [Register Crop Mark] under [Application Setting].